The Annoy Tools board typically serves as an interface between an or Uno and A4988 or DRV8825 stepper motor drivers. It translates G-code commands into physical movement. Key Specifications Voltage: 12V–36V DC input. Axes: Supports 3-axis (X, Y, Z) plus a clone axis (A). Firmware: Compatible with GRBL 0.8, 0.9, and 1.1. Interface: USB connection via the Arduino microcontroller. 🔌 Hardware Installation
The is a popular choice for DIY enthusiasts building small-scale engraving and milling machines. This manual provides a comprehensive guide to setting up and troubleshooting your board. 🛠️ Board Overview annoy tools cnc board manual pdf
Ensure the correct COM port and 115200 baud rate are selected. The Annoy Tools board typically serves as an
Always wire a physical emergency stop button to the "Abort" pins. Axes: Supports 3-axis (X, Y, Z) plus a clone axis (A)
Place jumpers under the driver seats to set Microstepping (usually all 3 jumpers for 1/16 step).
Seat the Arduino firmly into the center headers.
The board relies on , an open-source high-performance G-code parser. 1. Flashing GRBL Download the GRBL source code. Open the Arduino IDE. Flash the grblUpload sketch to your Arduino. 2. Configuration Settings