Store and operate the device within the specified temperature and humidity limits to prevent internal condensation or damage to plastic components. 3. User Interface & Basic Operation
Always separate probe and digital input cables from high-power inductive load cables. Never run signal and power lines through the same conduit.
The controller features a bright and a simple keypad for adjustments.
Monitors and controls temperatures from -50 °C to +150 °C .
By default, the display shows the temperature from the primary probe (B1). Changing the Set Point: Press the SET button briefly. Use the UP and DOWN arrows to adjust the desired value. Press SET again to confirm and save.
After modifying values with the arrows, you must press SET for at least 3 seconds to definitively save the new settings. If no button is pressed for 60 seconds, the device will exit without saving (timeout). Installation manual - Tempatron
Correct installation is critical to prevent electromagnetic interference and hardware failure.
Typically features two control zones (relay outputs) for managing multiple regulation stages, such as a compressor and an alarm or a heater and a fan.