If the system stops dispensing, check these common points first:

The LCD will display fault conditions, such as "Low Level" or "Pressure Fault," which can be cleared via the reset key once the issue (e.g., refilling the reservoir) is resolved.

Utilize the "push-to-connect" terminal strips inside the unit for easy component installation. Ensure all proximity switches and solenoid valves are wired according to the specific schematic provided with your model. Programming Your Controller

Allows you to control up to four different lubricators or zones with distinct settings.

Select a flat, vibration-free surface near the conveyor. Most units come with standard mounting hardware and brackets.

Proper electrical and mechanical installation ensures the controller survives harsh industrial environments.

The processor includes a memory backup feature that automatically restarts lubrication cycles following a power failure.

If the "shot" isn't reaching the chain, adjust the regulator on top of the central pumping station to increase system pressure.

Turn the pumping station switch to "ON." The controller should display a continuous readout of the current channel status.