Remove the four stud screws from the bottom of the scale base.
Standard interfaces include 1x RJ45, 1x RS232, and 1x RJ9 cash drawer port. Operational Setup & Maintenance digi sm320 service manual
Route the label through the designated path and secure the end into the red take-up component. Remove the four stud screws from the bottom
Securely connect the serial cables between the scale and the pole, ensuring the latches click. Securely connect the serial cables between the scale
Load the label roll onto the spool, following the internal guide rails for orientation.
Standard 2MB (8,300 PLUs), upgradable to 4MB (18,000) or 8MB (38,000).
To enter calibration mode, press the Span Switch , then in Z-Mode, hold RE-ZERO and enter code 8715 . Follow the on-screen prompts to place test weights (e.g., 3kg for a 15kg capacity scale) and press the asterisk * key to finalize.