Connect Channel A to one side of your LC filter and Channel B to the other. Set the oscilloscope to "AC" mode.
Move the downloaded .LIB and .IDX files into this folder.
Connect the voltage feedback pin (VFB) to the output via a potential divider to allow the chip to regulate the voltage. 2. Oscilloscope Configuration To visualize the results: Place an Oscilloscope from the instruments toolbar.
If you’ve pasted the files but can't find the part, ensure you are looking in the "Data\LIBRARY" folder, not the "Bin\LIBRARY" folder.
Once installed, you can find the device by pressing in the schematic capture window and typing "EGS002." 1. Basic Circuit Setup
Run the simulation. You should see a high-frequency PWM signal before the filter and a smooth 50/60Hz sine wave after it. Common Troubleshooting Tips
Search for "EGS002 Proteus Library zip" on engineering forums or GitHub. You are looking for two specific files: .LIB and .IDX . Locate Your Library Folder: Navigate to your Proteus installation directory.
