Gilbarco Sk700 Programming Manual -

Before modifying any internal parameters, the dispenser must be put into a state that allows configuration changes. Most high-level programming requires physical access to the processor board to engage "Calibration Mode" or perform a "Cold Start".

Identifies the hardware configuration (suction vs. pressure).

, focusing on basic setup, configuration codes, and troubleshooting procedures. 1. Preparing for Programming Gilbarco Sk700 Programming Manual

Sets maximum flow rates for different fuel grades (e.g., 40L/min vs 80L/min). Country Code

Configures the communication method (e.g., Gilbarco 2-Wire, IFSF-Lon). 5. Troubleshooting with Error Codes Before modifying any internal parameters, the dispenser must

Programming is performed using the located inside the dispenser’s head unit. Press the F1 key to initiate the command entry.

A cold start is typically only required for major re-configurations or to clear catastrophic memory errors. This involves moving a two-wire jumper to the "Cold Start" position before powering up. 2. Entering the Programming Menu pressure)

For many settings, including meter calibration, the CAL switch must be moved to the left (CAL position).

The display will show a 0 , indicating the unit is ready for a Function Code (FC) or Command Code (CC). 3. Essential Command Codes (CC)

This article serves as a guide for technicians and site managers on navigating the Gilbarco SK700 Programming Manual