Modbus Poll Bytes Missing Error Fixed -
If you ask for 100 registers but the slave only has 50, the slave might send an exception code or a truncated packet.
The Modbus standard dictates that if you use No Parity , you must use 2 Stop Bits . If you use Even or Odd Parity , use 1 Stop Bit . Many users fail this "8-N-2" vs "8-E-1" rule. 4. Address Buffer Overruns and USB Converters modbus poll bytes missing error fixed
Go to Windows Device Manager > Ports > COM Port > Advanced. Try lowering the Transmit and Receive FIFO buffers. This forces the driver to process smaller chunks of data more frequently, preventing byte loss. 5. Check Slave ID and Register Limits If you ask for 100 registers but the
Use Shielded Twisted Pair (STP) cable and ground the shield at one end only . Summary Checklist Potential Cause Reflections Add 120Ω termination resistors. Noise Use shielded cables; separate from power lines. Timing Increase Response Timeout in Modbus Poll. Framing Match Baud, Parity, and Stop Bits exactly. Hardware Replace cheap USB converters with FTDI-based ones. Many users fail this "8-N-2" vs "8-E-1" rule
Are you using a or a Modbus TCP gateway for this setup?
