Attempted cycle start without the chuck being properly clamped. DOOR NOT CLOSED The machine door is open, preventing cycle initiation. EX0069 DOOR LOCK CHECK TIME OVER
The door lock confirmation signal did not reach the control within the allotted time. TURRET ILLEGAL MOVEMENT mori seiki ex alarm list
The turret station number is out of the parameter range set for the machine. MILL SPINDLE ALARM A fault in the milling spindle amplifier or drive unit. EX1001 HYDRAULIC UNIT ALARM Attempted cycle start without the chuck being properly
Mori Seiki "EX" alarms are PLC-related messages that originate from the machine tool builder rather than the underlying CNC control (such as Fanuc or Mitsubishi). These alarms typically indicate mechanical, electrical, or sequence-related issues specific to the machine's peripheral hardware, such as the hydraulic unit, automatic tool changer (ATC), or door interlocks. TURRET ILLEGAL MOVEMENT The turret station number is
Indicates a general failure on the operation panel or flat-panel, often requiring a hardware check. IMPROPER TURRET
The hydraulic power unit reports a fault, such as low pressure or readiness failure. SENSORING TOOL IN SPINDLE