Sup0108 Top -

This occurs when the iDRAC interface believes a system update is already running, preventing you from starting a new one. This can happen even if no update is visible, often due to a "stuck" job or a leftover RAM drive from a previous attempt. Top Solutions to Fix SUP0108

If you encounter this block, use these methods to clear the iDRAC queue:

: You can perform a soft reset of the iDRAC through the web interface or by holding the "i" button on the front of the server for 15 seconds. This restarts the management controller without affecting the host operating system. Clear the Job Queue : Use the Dell Lifecycle Controller sup0108 top

The message usually reads: "A deployment or update operation is currently in progress. Please wait for it to complete before retrying."

: Shutting down the server and removing power for a few minutes is often necessary to clear the RAM drive where firmware installers extract files. This occurs when the iDRAC interface believes a

or command-line tools (racadm) to delete pending or "scheduled" jobs that may be blocking the update.

: For initial configurations, ensure you are using the default iDRAC IP address (usually 192.168.0.120 ) to avoid connectivity drops during updates. or command-line tools (racadm) to delete pending or

: In some cases, the iDRAC firmware installer places a lock on the system that can take up to 18 hours to clear automatically if not manually reset.

The error code is a specific event message related to Dell iDRAC (integrated Dell Remote Access Controller) and the Lifecycle Controller

: Avoid firmware updates when the CPU is under heavy load, as high utilization can interfere with the iDRAC's ability to communicate with the fan speed controllers and sensors during the flash process. Preventing Update Issues