Update Ktag Clone From 225 To 270 New Instant

Open version 2.25 and check the protocol list. You should now see that previously "greyed out" or missing protocols are now active and selectable.

The software should automatically initiate a "protocol update." This process can take several minutes to an hour depending on your system and SD card speed. 3. Finalizing and Testing

Open the folder and run the driver installer provided within that specific folder. Reconnect the K-TAG tool and open the 2.70 software. update ktag clone from 225 to 270 new

: Only enable this at specific steps indicated below. Caution : Connecting a clone device to the internet at the wrong time can permanently block the NXP chip. Step-by-Step Update Guide 1. Initial Software Installation

Install first. This version is often used as a baseline for the firmware to recognize the hardware correctly. Install the required drivers as an administrator. Open version 2

completely before you begin.

: Adds compatibility for modern Bosch EDC17 and MED17 units, including improved checksum correction for certain microprocessors. : Only enable this at specific steps indicated below

Connect your K-TAG device via USB and confirm it is detected by the computer.

After the update completes, the 2.70 software may not be the most stable for writing; many users return to to perform actual ECU operations.