V2000-c Rfid Access Control User Manual May 2026

To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults

Always change the default Master Code immediately after installation to prevent unauthorized access to your programming settings.

Verify the input voltage is a steady 12V DC. V2000-c Rfid Access Control User Manual

Check for a short circuit in the wiring or an "anti-tamper" alarm trigger.

The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring To adjust how long the door remains unlocked

To enter programming mode, you must use the . The factory default Master Code is 999999 .

Press * + 999999 + # . (The indicator light will turn orange/flashing). Exit Programming Mode: Press * . Access Mode Configuration You can choose how users

V2000-C RFID Access Control User Manual: A Comprehensive Guide

The system is a popular, standalone security solution designed for small to medium-sized businesses, residential complexes, and secure storage areas. This guide serves as a comprehensive manual to help you install, program, and maintain your device. 1. Introduction & Specifications

To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults

Always change the default Master Code immediately after installation to prevent unauthorized access to your programming settings.

Verify the input voltage is a steady 12V DC.

Check for a short circuit in the wiring or an "anti-tamper" alarm trigger.

The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring

To enter programming mode, you must use the . The factory default Master Code is 999999 .

Press * + 999999 + # . (The indicator light will turn orange/flashing). Exit Programming Mode: Press * .

V2000-C RFID Access Control User Manual: A Comprehensive Guide

The system is a popular, standalone security solution designed for small to medium-sized businesses, residential complexes, and secure storage areas. This guide serves as a comprehensive manual to help you install, program, and maintain your device. 1. Introduction & Specifications